Bosch B450 Instalační příručka stáhnout pdf (Strana 118)

Value Description

0 Panel does not answer

1 to 13 Number of rings until panel answers

14 Answering machine bypass 2

15 Answering machine bypass 1

This location sets the number of rings before the control panel answers an incoming call. Set

this count to an acceptable level, noting that one ring is “Ring, Ring – Ring, Ring” and that a

Ring Count of 10 represents approximately 60 sec. This location has an effect only if Remote

Arming, remote Upload/Download using A-Link Plus, or both are enabled. Programming this

location to 0 prevents the control panel from answering incoming calls regardless of other

programmed options.

Answering Machine Bypass

Answering Machine Bypass allows a connection with the control panel for Remote Arming or

Upload/Download when an answering machine or facsimile machine is on the same telephone

line. Answering Machine Bypass has two different methods. Program a 14 to use the

secondary method only when there is a large amount of traffic on the line (at a home office,

for example). This method reduces the chance of the control panel incorrectly answering an

incoming call.

Programming the Ring Count to 15 enables Answering Machine Bypass in the primary mode.

When calling the control panel, allow the telephone to ring no more than four times and then

hang up. If after 8 seconds you call again within 45 sec, the control panel answers the call on

the first ring and the connection is established. This prevents the answering machine or

facsimile machine from answering the call. To enable Answering Machine Bypass only when

the system is armed, select Option 2 in Location 177.

Program the Ring Count to 14 to enable Answering Machine Bypass in the secondary mode. In

this case, call the control panel and allow the phone to ring no more than twice and hang up.

Wait a minimum of 8 sec and call the control panel again. The control panel answers on the

first ring. If you do not wait the 8 sec, the control panel does not answer the call. To enable

Answering Machine Bypass only when the system is armed, select Option 2 in Location 177.

Notice!

Set the Ring Count for the answering machine or facsimile machine to a value greater than

two rings. Four to six rings is preferred.

Program a 0 into this location to disable the control panel from answering an incoming call.

Telephone Line Fail Options

Item Location Default

Telephone Line Fail Options 176 0

Value Description

1 Display FAULT indicator when the telephone line fails

2 Sound alarm when system is armed

13.9

118 en | Communicator Information Control Panel

2014.07 | 00n | F01U298026 Installation Guide

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 151 152

Žádné komentáře

Bosch B450 Instalační příručka Strana 118