Bosch DS7400XiV4-EXP Specifikace stáhnout pdf (Strana 13)

DS7400XiV4-EXP | Reference Guide | 3.0 Control Panel Installation EN | 13

Bosch Security Systems | 1/05| 4998154963B

Table 6: Options (continued)

Module Description Current Draw

MX775i Multiplex Passive

Infrared (PIR)

Intrusion Detector

200 µA, Standby; 2 mA

in Walk Test mode

MX794i The MX794 is a

Long Range

Multiplex PIR

Intrusion Detector

with Self-test.

800 µA, Standby; 2

mA, Alarm.

MX934i Multiplex Passive

Infrared (PIR)

intrusion detector.

200 µA, Standby; 2 mA

in Walk Test mode.

MX938i 360° Ceiling

Mount Multiplex

PIR Intrusion

Detector.

200 µA, Standby; 2.5

mA in Walk Test mode

DACM Door Access

Control Module

RF3222

RF3222E

120-zone Wireless

Receiver (up to

two receivers per

system. Requires

use of a DS7430

or DS7436

Multiplex

Expansion

Module.)

30 mA

2.5 Control Panel Package Formats

The control panel is also available in three package

formats:

Table 7: Package Formats

Package Description

DS7400XiF DS7400Xi in large red enclosure

manufactured from 1.2 mm (18 gauge)

cold-rolled steel, measuring 38.1 cm x

52.7 cm x 10.8 cm (15.0 in. x 20.75 in.

x 4.25 in.) (H x W x D).

DS7400XiFCP DS7400XiF package with DS7420i,

DS7447E/DS7447V2 and a AE-TR16.

DS7400XiCC DS7400Xi in an Attack Enclosure.

3.0 Control Panel Installation

The DS7400XiV4 Control Panel and the enclosure are

shipped together. The control panel, however, must be

installed into the enclosure. Hardware for mounting

the enclosure to a wall, and the control panel to the

enclosure is located in its own hardware pack.

Before servicing, remove all power

including the transformer, battery, and

phone line. A complete functional test is

required after any programming.

Incorrect connections may result in damage

to the unit.

The system is power limited except for

battery terminals. All wiring entering this

enclosure must be power limited.

An appropriate two-pole disconnect device

must be installed by qualified service

personnel, as part of the building installation.

3.1 Install the Enclosure

1. Knock out the desired wire entrances on the

enclosure.

2. Use the enclosure as a template and mark the top

mounting holes on the mounting surface.

3. Pre-start the screws (not supplied) for these holes.

4. Place the enclosure onto these screws. See Figure 1.

5. Tighten the screws.

6. Screw in the remaining two screws into the bottom

holes. See Figure 1.

Use proper anchor and screw sets when

installing the enclosure on non-load-

bearing surfaces, such as dry wall.

Use the screws provided to secure the

enclosure cover (see Figure 1).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 143 144

Komentáře k této Příručce

Žádné komentáře

Bosch DS7400XiV4-EXP Specifikace Strana 13

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Bosch DS7400XiV4-EXP