Bosch SF8172V Specifikace stáhnout pdf (Strana 62)

American Dynamics Fixed Camera (Illustra 600, 610 and 600LT Series Box and Bullets)

22-2 Camera Handler Release Notes

Required Network Ports

• Port 80 is for HTTP

• Port 554 is for RTP/RTSP

Default Username & Password

• Username: admin

• Password: admin

Limitations

• When a factory defaulted camera is added to an NVR, the default settings are: H.264, 7 FPS,

CIF. When the user wishes to change the settings they can for single streaming increase the

FPS and resolution to max and click Save. For dual streaming, user can enable 2nd stream by

selecting Alarm or Record. They should change the codec to MJPEG and click Save.

• To meet the highest single stream FPS, the user can enable dual stream on the NVR, configure

the stream codec/resolution/fps/quality for Stream 1, and then configure Stream 2 to lowest

resolution/fps/quality. Once Stream 2 is configured the user can disable it on the NVR.

Alternatively the user can access the camera's web GUI settings to change Stream 2 to the

lowest resolution/fps/quality. For some properties' the value is retrieved from camera itself

(resolution, frame rate, quality, brightness, contrast, sharpness) result in that when user adds the

camera, the return value is not the default value defined in the NVR, but the actual value in

camera.

• The camera will reboot when changing codec (audio or video), resolution, frame rate, key frame

interval, video quality, audio volume, enable audio/audio in or any other video/audio properties.

Average time for reboot is 30 seconds.

• Changing the video/audio codec or resolution may cause the RTSP service in the camera to

stop. With the camera failing to restart and set new streams, the workaround is to reboot or

power cycle the camera and reset stream settings.

• All streams will be lost when camera reboots and be automatically reestablished on startup.

• When the camera is rebooting, NVR video and audio properties may not be available to get or

set. Any changes made to these settings during reboot time will not be saved.

• In the NVR, under image settings the Video Standard will always display NTSC in the dropdown

list, irrespective of it being NTSC or PAL. For PAL cameras, FPS will show 25 as max FPS.

• When the primary and secondary streams are configured with the same codec on the camera

web GUI, changing stream on the NVR may change the opposite stream to the one you wish to

change. Stream 1 and Stream 2 on the NVR will not necessarily reflect primary and secondary

steams configuration on the camera. The camera only identifies the streams by the stream

codec (ignoring FPS and resolution). In some instances when NVR streams are both configured

with the same codec, changing one of the streams will not necessarily change the parameters

on the specified stream.

• It is recommended to configure the camera to the cameras FPS limitations. If the parameters

exceed the limitations, the camera performance may be affected. Factory defaulting the camera,

and adding to an NVR can resolve this performance issue. Once this is completed, reconfigure

the camera stream without exceeding stream limitations. Please refer to camera release notes.

• If the dual stream resolution/FPS is high, the video may be abnormal, a reboot or factory default

may resolve this issue.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 174 175

Komentáře k této Příručce

Žádné komentáře

Bosch SF8172V Specifikace Strana 62

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Bosch SF8172V