Bosch AMAX panel 4000 EN Instalační příručka stáhnout pdf (Strana 33)

To program the IP Address and port:

Use no punctuation in IP address. If any unit of IP address is less than 3 digits, use 0 to fulfill

the data in the higher bits. The remaining 5 digits will program the port. Port number ranges

from 0-65535. Any port is less than 5 digits, use 0 to fulfil the data.

Example

To program the IP Address 10.16.1.222:80 as the IP Address of Receiver 1, enter the following

sequence into Address 000 - 016:

[0 1 0 0 1 6 0 0 1 2 2 2 0 0 0 8 0]

Notice!

Programming option anti-replay, acknowledge wait time and pulse interval time are only used

in Conettix IP.

Telephone number for Receiver 1 - 4/IP Address and Port

When the corresponding data format for above programming address is a network

communication format, it is explained as an IP Address and Port. For a non network format, it

is explained as telephone number.

When the control panel transmits a report, it dials the telephone number/IP Address to

contact the monitoring station. If the call is successful, the relevant information is transmitted

and the dialer returns to Standby Mode.

Contact your monitoring station for the correct telephone number/IP Address before you

program these addresses.

Receiver Subscriber ID Number

Receiver 1 - 4 Subscriber ID Number

The Subscriber ID Number is transmitted to identify the calling control panel. Enter the

Subscriber ID Number in the six addresses provided for each destination. If a Subscriber ID

Number is less than 6 digits, use 0 to full fill the data in the higher bits.

Example

Program Subscriber ID Number as 4729 in six addresses: [0 0 4 7 2 9]

Receiver Transmission Format

Transmission Format

Receiver 1 - 4 Transmission Format

You can select the transmission format with Address options to specify how to transmit the

information to the base station receiver. If Contact ID or SIA format is selected, the

information is transmitted by telephone line; if Bosch Network is selected, then it is

connected with B426/DX4020 or ITS-DX4020G GPRS. Transmission format is defaulted as

Contact ID.

Transmission Formats (Contact ID, SIA, Conettix IP)

The AMAX panel 4000 / AMAX panel 4000 EN provides three kinds of transmission formats,

Contact ID, SIA and Conettix IP format for its dialing and communication features. Program

the transmission format for Receiver 1, 2, 3 and 4 separately in Address 023, Address 053,

Address 083 and Address 113 (refer to Transmission Format). The control panel is set at the

factory to report in the Contact ID Format.

7.1.2

7.1.3

AMAX panel 4000 / AMAX panel 4000

Settings | en 33

Bosch Sicherheitsysteme GmbH Installation Guide 2013.07 | 03 | F.01U.267.112

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 175 176

Komentáře k této Příručce

Žádné komentáře

Bosch AMAX panel 4000 EN Instalační příručka Strana 33

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Bosch AMAX panel 4000 EN