
Chapter
2.
Installation
-
A
CAUTION
If
the equipment
is
installed in
a
place which is
800
m
or higher than sea level
(i.e.
under
low
pressure in mountain areas), its specifications require to be changed. In this case,
be
sure to
contact
us.
Do
not
use
the
equipment
before
changing.
In
transporting the equipment, put the lid on
and
slide the opedclose lever to the end of the
close side
to
prevent the lid from opening.
When moving the lid, do
not
hold
it
by
the handle, otherwise the lid may become
difficult
to
close.
1.
Installation Instructions
O
Avoid installing the equipment in a place where
its body may be exposed to water or chemicals, or
where corrosive and explosive gases may
be
produced nearby.
Q
Avoid installing the equipment in a place which is
exposed to high humidity, direct sunlight or much
dust.
O
Avoid placing the equipment directly under a fire
detector. If you open the lid immediately after
completion of operation, steam comes out of the
working chamber, and may activate the detector.
@
Arrange the equipment with a clearance of 10 cm or
wider on the right side and
12
cm or wider on the rear
side to prevent the vent hole
fiom being blocked.
I
2
cm
or
over
1
10
cm
or
over
O
Avoid installing the equipment with its rear side
located near outlets or electrical appliances as steam
comes out of the exhaust port on the rear.
@
Avoid
an
installation place which is subject to impact
or vibration.
6
Place the unit in a level,
fm
place.
@
Avoid installing in
a
place which is subjected
to
a
room temperature of
5°C
or below or
35OC
or above.
Komentáře k této Příručce