Bosch K2200 Series Specifikace stáhnout pdf (Strana 15)

Toll Free Customer Service: 1-800-414-3038

Customer Service FAX: 1-800-414-3039

The K2012 Wiegand Interface connects between another technology

reader (with a Wiegand output) and the K2200 and K1200 Series Door

Controllers, the K6300-PC, or the K6100-PC Desktop Administration Kit.

The K2012 converts a 26-bit Wiegand reader’s data into a format

compatible with a reader’s signal output. Include the K2012 into

applications with more than one Wiegand device on the same line or into

applications using K2100 and K1100 Door Controller Series devices with

Wiegand devices.

Features

Dual-color diagnostic LEDs

Tamper switch

Functions

Dual-color Diagnostic LED

When turned on, the LED flashes rapidly five times immediately

followed by five additional half-second pulses before the LED settles

into its normal operation flash pattern. During normal operation, the

LED pulses green once every second. When a card is presented and is

correctly read, the LED flash frequency increases for a period of one to

two seconds. This indicates that the code has been read and sent, but

not that access will be granted.If a tamper condition is sensed, the

LED will pulse red once every second until the tamper condition is

corrected.

Tamper Switch

When you open the K2012 cover, a spring tamper switch on the board

indicates a tamper condition through the dual-color diagnostic LED. In

a tamper condition state, the K2012 does not allow the reader to

function.

Installation/Configuration Notes

The wire length from the door controller to the K2012 is up to 3000 ft

(914m) when using 18 AWG (1.2 mm) cable.

K2012 WIEGAND INTERFACE

READYKEY

™

COM PATIBL E

Technical Specifications

Connections

Minimum 22 AWG (0.8 mm) standard

six-wire alarm cable, unshielded

Relative Humidity:

0% to 90%, non-condensing

For UL Listed applications, 0% to 85%,

non-condensing

Temperature (Operating):

-31°F to +140°F (-35°C to +60°C)

For UL listed applications, +32°F to

+120°F (0°C to +49°C)

Power Requirements for Readykey Reader Connector

Current (Maximum): 80 mA

Voltage (Operating): 10.2 VDC to 18 VDC at the reader

Power Requirements for Wiegand Reader Connector

Current (Maximum):

50 mA, current limited by door

controller

Voltage (Operating): 5 VDC at the reader

Ordering Information

K2012 Wiegand Interface

Includes a metal case. Transfers data between the

door controllers and the Wiegand reader. Required

when using two Wiegand 26-bit format readers on

a single channel, a K2015A Alarm Event Manager

(AEM), or a K2015B AEM.

K2012 7S-K2012

Certifications and Approvals

UL ALVY: Access Control Systems Units (UL294), APOU: Proprietary

Alarm Units (UL1076), UEHX7: Signaling Appliances,

Miscellaneous Certified for Canada (cUL)

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Komentáře k této Příručce

Žádné komentáře

Bosch K2200 Series Specifikace Strana 15

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Bosch K2200 Series