Bosch ISW-BIT1-HAX WLSN INSTALLATION Specifikace stáhnout pdf (Strana 18)

wLSN | Reference Guide | 2.0 General Installation

18 Bosch Security Systems, Inc. | 3/07 | F01U009440-01

2.5 Defaulting a wLSN Device (Undiscovered State)

Discovery is the process through which the wLSN Hub identifies

and includes new devices into a system. Only undiscovered

devices can be placed in RFSS mode. To ensure a device is

undiscovered:

1. Remove the batteries.

2. Press and hold the tamper switch button.

Refer to Figure 1 on page 13.

3. Reinsert the batteries while holding the tamper switch

button.

The device’s LED turns on.

4. Release the tamper switch button within five sec after the

device’s LED turns on.

The device’s LED briefly turns off and then on, indicating that

the device was returned to an undiscovered state.

This process does not work for the wLSN Smoke Detector.

Refer to Section 13.7 Returning the Smoke Detector to an

Undiscovered State on page 48.

If the wall tamper tab is removed on the Glassbreak

Detector, refer to Section 14.5.2 Returning the Glassbreak

Detector to an Undiscovered State on page 58 to enter

RFSS Mode or return the Glassbreak Detector to an

undiscovered state.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 59 60

Žádné komentáře

Bosch ISW-BIT1-HAX WLSN INSTALLATION Specifikace Strana 18