Bosch ISW-BIT1-HAX WLSN INSTALLATION Specifikace stáhnout pdf (Strana 13)

wLSN | Reference Guide | 2.0 General Installation

Bosch Security Systems, Inc. | 3/07 | F01U009440-01 13

Figure 1: Device Tamper Switches

1- Button style tamper switch

2- Lever style tamper switch

3. Hold the device at the planned mounting location.

4. Determine if the RF signal strength is acceptable by

observing the device’s LED flash pattern (Table 3). The flash

pattern appears for 10 min.

Table 3: LED Flash Patterns in RFSS Mode

LED Flash Pattern Signal Strength

Flashes at 1 sec intervals

No packets received or unacceptable

signal strength condition.

Flashes rapidly (0.2 sec interval) Acceptable signal strength

If the RFSS is unacceptable, reposition the device until an

acceptable location is found. If necessary, reposition the

wLSN Hub.

5. Repeat this procedure for each device you are testing. When

you finish testing the devices, return the wLSN Hub’s

switches to their original position.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Žádné komentáře

Bosch ISW-BIT1-HAX WLSN INSTALLATION Specifikace Strana 13