Bosch D7212G Instalační příručka stáhnout pdf (Strana 7)

DX4020-EXP | Installation Guide | 6. IP Programming EN | 7

Bosch Security Sys | 8/04 | F01U002192B

5.2 Xport LEDs

The DX4020 has two Xport LEDs located on the

Lantronix

Xport™ NIM. See Figure 12 and Table 3 for

more information.

Figure 12: Dx4020 Xport LEDs

1 - Left LED

2 - Right LED

Table 3: Xport LEDs

Left LED Right LED

State Color State Color Meaning

Off Off No Ethernet Link

Off Solid Amber 100 BASE-T Half

Duplex Link

Off Blinking Amber 100 BASE-T Half

Duplex; Activity

Off Solid Green 100 BASE-T Full

Duplex Link

Off Blinking Green 100 BASE-T Full

Duplex; Activity

Solid Amber Off 10 BASE-T Half

Duplex Link

Blinking Amber Off 10 BASE-T Half

Duplex; Activity

Solid Green Off 10 BASE-T Full

Duplex Link

Blinking Green Off 10 BASE-T Full

Duplex; Activity

6. IP Programming

Use this section to set up the initial IP address so that

the DX4020 can be set with a Network IP address.

The setup consists of using resident commands and

programs such as the commands ARP and Ping, and

the program Telnet available in the Microsoft

Windows operating system.

The IP, MAC address, and port number

used here are for demonstration only.

A working knowledge of DOS commands,

Windows

, networks and their operation is

required.

If your installation uses DHCP to obtain an

IP address and Port 7700 for

communication, see your control panel’s

documentation for instructions unless you

plan to use RPS over the network through

the DX4020. If so, proceed to the next

section.

6.1 Factory Programmed IP

Configuration

The DX4020 is shipped with the following default IP

address:

• Default IP Configuration Number: DHCP

• Default Port: 7700

• Default DHCP Device Name: Cxxxxxx

xxxxxx = last 6 digits of the MAC address

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Komentáře k této Příručce

Žádné komentáře

Bosch D7212G Instalační příručka Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Numerické klávesnice Bosch D7212G