Bosch D7212G Instalační příručka stáhnout pdf (Strana 10)

DX4020-EXP | Installation Guide | 6. IP Programming EN | 10

Bosch Security Sys | 8/04 | F01U002192B

5. Click Connect and wait a few seconds for a

connect failed message to display stating: “Could

not open a connection to 172.17.10.70.”

Click OK to open the Telnet window again.

6. Repeat Step 3.

This time, leave everything as it is except, type

9999 into the P

ort field. Click Connect.

7. The message "Press Enter to go into setup mode"

message appears. Press [ENTER].

If you do not press [ENTER] within five

seconds of seeing “Press Enter to go into

Setup Mode,” you are disconnected. If you

are disconnected, the following message

displays:

8. If you pressed [ENTER] within 5 seconds of seeing

the “Press Enter to go into Setup Mode” message,

you should see the following screen:

9. Press [0] then [ENTER] to set up the basic Server

configuration.

If the DX4020 Network Interface Module was

programmed with an IP address in the past, it is

displayed in parentheses (as shown below).

For example, if this DX4020 was originally

programmed to IP address 172.30.3.36, we would

be changing it to address 190.200.128.219.

10. Press the following keys to properly program IP

Address 190.200.128.219: 190.200.128.219

[ENTER]

If using DHCP (Dynamic Host Configuration

Protocol), the following would be entered:

0.0.0.0 [ENTER].

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Žádné komentáře

Bosch D7212G Instalační příručka Strana 10