DX4020-EXP | Installation Guide | 6. IP Programming EN | 11
Bosch Security Sys | 8/04 | F01U002192B
11. When asked to set the Gateway address, if it is not
needed, or if it is using DHCP, type N [ENTER].
If it is needed, type Y and the gateway IP address
as: 190.200.128.1 [ENTER].
The Gateway IP is only needed if using a
Wide Area Network (WAN). In a Local
Area Network (LAN), typically the
Gateway is not needed.
The following displays:
If the Netmask needs to be changed from the
default, enter the number of bits that correspond to
the Netmask your network is using (see Table 4). If
using DHCP, press [ENTER].
See your network administrator for more
information.
Press [ENTER] after entering the correct number
of bits for the netmask.
Table 4: Netmask Addresses
Host
Bits
Netmask Host
Bits
Netmask
1 255.255.255.254 17 255.254.0.0
2 255.255.255.252 18 255.252.0.0
3 255.255.255.248 19 255.248.0.0
4 255.255.255.240 20 255.240.0.0
5 255.255.255.224 21 255.224.0.0
6 255.255.255.192 22 255.192.0.0
7 255.255.255.128 23 255.128.0.0
8 255.255.255.0 24 255.0.0.0
9 255.255.254.0 25 254.0.0.0
10 255.255.252.0 26 252.0.0.0
11 255.255.248.0 27 248.0.0.0
12 255.255.240.0 28 240.0.0.0
13 255.255.224.0 29 224.0.0.0
14 255.255.192.0 30 192.0.0.0
15 255.255.128.0 31 128.0.0.0
16 255.255.0.0
12. If using DHCP, the following appears:
If you want to assign a name for this device for use
on a LAN, type Y and enter up to 16 characters
and [ENTER]. Otherwise just press [ENTER].
If planning to use RPS over a network
through this device, a unique name must
be entered here. This name should be
known to the person who is programming
the panel.
If no DHCP device name is entered, a
default name of Cxxxxxx is used (where
xxxxxx is the last six digits of the MAC
address).
13. Change the Telnet password by pressing [Y] and
entering a password or press [ENTER] to leave at
default of “No.”
This screen shows the Setup Mode screen you saw
previously.
If a password is entered, store it in a
secured place. If the password is lost or
forgotten you cannot telnet this unit again
until the DX4020 is sent back to the
factory and reconditioned.
14. Press [1] [ENTER] to go into setup Channel 1
configuration.
15. Press [Enter] to accept the Baud Rate default of
(9600). If 9600 is not the default, type 9600 and
press [ENTER] to change it.
(26 stránky)
(104 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce