Bosch X40 Uživatelský manuál stáhnout pdf (Strana 79)

VideoJet X40 SN Configuration Using a Web Browser | en 79

Bosch Security Systems Installation and Operating Manual DOC | V4.0 | 2009.06

Operating mode

Select an operating mode for the relay.

For example, if you want an alarm-activated lamp to stay on after the alarm ends, select

Bistable. If you wish an alarm-activated siren to sound for ten seconds, for example, select

10 s.

Relay follows

If required, select a specific event that will trigger the relay. The following events are possible

triggers:

– Off

Relay is not triggered by events

– Connection

Trigger whenever a connection is made

– Video alarm

Trigger by interruption of the video signal at the corresponding input

– Motion alarm

Trigger by motion alarm at the corresponding input, as configured on the VCA page (see

Section 5.31 Advanced Mode: VCA Event Triggered, page 73)

– Local input

Trigger by the corresponding external alarm input

– Remote input

Trigger by remote station's corresponding switching contact (only if a connection exists)

Relay name

You can assign a name for the relay here. The name is shown on the button next to Trigger

relay. The Livepage can also be configured to display the name under the relay icon.

Trigger relay

Click the button to trigger the relay manually (for testing or to operate a door opener, for

example).

NOTICE!

The numbers in the lists of selectable events relate to the corresponding connections on the

unit, Video alarm 1, for example to the Video In 1 connection.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 129 130

Žádné komentáře

Bosch X40 Uživatelský manuál Strana 79