Bosch SE2005 Průvodce nastavením stáhnout pdf (Strana 40)

Security Escort | Installation and Setup Guide |5.0 Testing

and Troubleshootin

g

EN | 40

Bosch Security Systems | 1/09 | 33831E

d. Take the Maintenance Transmitter

and go to the selected receiver.

The red and green light should

be lit when you arrive at the

first receiver location.

e. Transmit an alarm from the

Maintenance Transmitter. The

receiver should activate by

flashing the red lights and

sounding the sounder (if the

sounder jumper is in place on

the receiver). This confirms

that the RF portion of the

receiver is working and you are

at the right location. The

software then turns off the LEDs

on the tested receiver. The

receiver with the next higher

point number is automatically

selected and it’s red and green

LEDs light.

f. Proceed to that receiver and

perform the same operation with

an alarm on the Maintenance

Transmitter until the operation

of all receivers is confirmed

and all receivers are working

and in their proper location on

that transponder. If the LEDs

fail to light, the LED jumpers

may be missing on that receiver,

the receiver may be set to the

wrong address, or you may be at

the wrong location. If the LEDs

are lit but the receiver fails

to respond to the maintenance

alarm, there may be a problem

with the receiver board or

another receiver is receiving a

stronger signal

.

8. Repeat the above sequence starting

with Step 1 for all transponders

and receivers in the system.

5.0 Testing and

Troubleshooting

5.1 Built-In Troubleshooting

Aids

Note:

Refer to Section

5.4

Troubleshooting Reference for

wiring troubleshooting where

applicable.

5.2 Receiver

5.2.1 Jumpers

There are two groups of jumpers on the

EA102A-304 Receiver. The first group

contains jumpers P1 through P3. The

second contains Jumpers P4 through P8.

The function of each jumper is

indicated in

Table 8:

Table 8: Jumper Operation

Jumper Operation with Jumper in

Place

P1* Sounder is enabled

P2* Green LED is enabled

P3* Red LED is enabled

P4** Test Mode is enabled

P5** Receiver Spacing Mode is

enabled

P6** Left Antenna is disabled

P7** Right Antenna is disabled

P8 Do not place a jumper across

these pins

* Remove jumpers P1, P2, and P3 when

installed in an outdoor enclosure.

** Remove jumpers P4, P5, P6, and

P7 for normal operation.

5.2.2 Test Mode

Each EA102A Receiver provides a Test

Mode that may be used to check the

unit’s function. The module goes into

Test Mode when jumper P4 is in place

(jumper P5 removed). In this mode, all

test and alarm receptions are sounded.

Note:

The sounder and LEDs (jumpers P1,

P2, and P3) must also be enabled to

operate the Test Mode.

Each receiver should be tested using

the following method (test only one

receiver at a time):

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 53 54

Komentáře k této Příručce

Žádné komentáře