Bosch SE2005 Průvodce nastavením stáhnout pdf (Strana 36)

Security Escort | Installation and Setup Guide |3.0

Installation Instructions

EN | 36

Bosch Security Systems | 1/09 | 33831E

3.4.4 ProxLink Setup

Configuration Procedure

Note:

For more details refer to the

ProxLink Radio Module User’s

Manual.

Required Equipment

• ProxLink Radio Module

• PC with RS-232 port running a

terminal emulation software

package. Select Start → Programs

→ Accessories. Click Hyper

Terminal.

• ProxLink DB-9 to DB-25 Female RS-

232 Cable

• 9 VDC Power Supply

Configure

Select one of seven radio channels

(902 MHz to 928 MHz). Make certain

that the channel chosen is the same

for all the ProxLink located at the

transponders and for the ProxLink at

the central console computer.

Select one ProxLink for your central

control computer. The serial number

(located on a silver tag on the bottom

of the ProxLink) of this ProxLink must

be entered in the Destination Serial

Number and Serial # Filter location on

all ProxLink Radios connected to the

transponders.

1. Attach the PC to the ProxLink using

the ProxLink RS-232 cable. Attach

the DB-9 Connector to the ProxLink

and attach the DB-25 female

connector the PC. Gender changers

or DB-25 to DB-9 converters may be

required depending on your serial

port connector type.

2. Start your terminal emulation

software (Hyper Terminal).

Configure the ProxLink as follows:

9600 Baud, 8 Data Bits, 1 Stop Bit,

and no parity.

3. Put the ProxLink in User Interface

Mode by pressing the

[CONFIGURATION] button on the front

of the unit. The ProxLink should

respond by displaying the Main Menu

screen.

4. Once the Main Menu displays,

configure a ProxLink parameter by

selecting a menu option and

pressing the [ENTER] key. This

either displays a prompt or a sub-

menu. After finishing with a sub-

menu, press the [ESC] key to return

to the previous menu.

5. After you finish configuring the

ProxLink, type [L] [ENTER], then

type [Y] to place the unit in

operating mode.

Configuration should look as follows

in Main Menu, D - Display ProxLink

Radio Module Parameters:

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 53 54

Komentáře k této Příručce

Žádné komentáře