Bosch LTC 8555 Manuál s instrukcemi stáhnout pdf (Strana 52)

EN

|

52

Bosch Security Systems | December 8, 2004

LTC 8100, LTC 8200, LTC 8300 Series | Instruction Manual | Error Messages

Error Description Error Description

Error 55 -

SEQUENCE priority

The switcher sequence being requested or

cleared requires monitors that are in use by

a user of equal or higher priority. Contact a

user with higher priority, or have the

system administrator clear the monitors in

question.

Error 80 -

Trunk not available

An attempt was made to access a

remote camera connected to a

satellite system, but no unused

trunk lines are currently available.

Error 56 -

SEQUENCE request

The user has tried to load a sequence that

is being edited in the PROGRAM mode.

Once editing has been completed, the

sequence may be loaded.

Error 81 -

Satellite Trunk Siezed

The camera currently viewed has

changed because an operator with

a higher priority has selected a

different camera that seized the

trunk line from the satellite.

Error 58 -

SEQUENCE request

The sequence being requested is a Relative

sequence, and the user is only permitted

access to Absolute sequences.

Error 89 -

Internal stack error

A stack overflow has occurred

within the system. Report this to

the manufacturer.

Error 60 -

PROGRAM request

The user has tried to program a sequence

that is currently running. The sequence

must first be stopped before any editing

can be performed.

Error 90 -

Keyboard entry undefined

The keyboard entry is not defined.

Check the appropriate section of

the instruction manual for the

desired operation and try again.

Error 62 -

PROGRAM request

The user has tried to program a new

sequence when the system is out of

sequence memory space. Delete unused

sequences and then program the new

sequence.

Error 92 - Keyboard entry out of

range

The data entered for a valid

command was not in the permitted

range. Check the appropriate

section of this instruction manual

for the acceptable ranges for the

command in question and try

again.

Error 63 -

PROGRAM request

Some other user is already programming a

sequence on this monitor.

Error 94 - Keyboard entry invalid

An invalid character has been

received from the keyboard,

usually caused by a

communication error. Verify that

the keyboard-to-system cable is

securely connected.

Error 70 -

Monitor not allocated

to alarm monitor

group

This monitor cannot be used for alarm

operations; it has not been designated as

alarm-capable by the system programmer.

Error 95 - Keyboard entry

incomplete

The control sequence sent from the

keyboard was incomplete, usually

indicating a communication error.

Verify that the keyboard-to-system

cable is not producing an

intermittent connection.

Error 71 -

Step monitor required

A group of alarm monitors may not have

an armed Review (display) monitor without

having armed Step (sequence) monitors.

Error 96 - * (STAR) undefined

The * key has been pressed, but

there is no definition for this

button.

Error 78 -

Must enter alarm

number

A specific alarm number must be entered

when arming or disarming an alarm.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 63 64

Komentáře k této Příručce

Žádné komentáře