Bosch 3725DEVS Návod k použití a péči stáhnout pdf (Strana 9)

-9-

surfaces, plastics, and even glass. The tool is

operated in much the same way as when

s

anding, but the following points should be

o

bserved;

Apply the compound to the surface, and use

the sponge applicator pad with light pressure

and a circular motion to remove scratches and

restore weathered finishes. Use only as much

compound as necessary, and clean the

sponge frequently during use.

When initial polishing is completed, wipe away

any excess compound with a soft towel, and

then polish the surface to its final finish with the

polishing bonnet. Use smooth overlapping

strokes for best results.

It is important to note that the orbit speed of

the random orbit sander is not the same as the

R

PM of a standard right-angle polisher. The

r

andom orbit action is much like a powerful

hand polishing action, and therefore does not

have the high speeds at the edge of the pad

which can burn the work surface. For this

reason, it is possible to select a higher OPM

for the random orbit sander than the

recommended RPM for a standard polisher.

Practice on a hidden area or test surface until

you have determined the tool is suitable for

your polishing application.

Clean the buffing pad and polishing bonnet

with mild detergents and warm water. DO

NOT use solvents.

Service

Preventive maintenance

performed by unauthorized

personnel may result in misplacing of

internal wires and components which

could cause serious hazard.

We

recommend that all tool service be performed

by a Bosch Factory Service Center or Autho-

rized Bosch Service Station.

TOOL LUBRICATION

Your Bosch tool has been properly lubricated

and is ready to use. It is recommended that

tools with gears be regreased with a special

gear lubricant at every brush change.

CARBON BRUSHES

The brushes and commutator in your tool

have been engineered for many hours of

dependable service. To maintain peak

efficiency of the motor, we recommend every

two to six months the brushes be examined.

Only genuine Bosch replacement brushes

specially designed for your tool should be

used.

BEARINGS

After about 300-400 hours of operation, or at

every second brush change, the bearings

should be replaced at Bosch Factory Service

Center or Authorized Bosch Service Station.

Bearings which become noisy (due to heavy

load or very abrasive material cutting) should

be replaced at once to avoid overheating or

motor failure.

Cleaning

To avoid accidents always

disconnect the tool from

the power supply before cleaning or

performing any maintenance.

The tool may

be cleaned most effectively with compressed

dry air.

Always wear safety goggles when

cleaning tools with compressed air.

Ventilation openings and switch levers must

be kept clean and free of foreign matter. Do

not attempt to clean by inserting pointed

objects through openings.

Certain cleaning agents

and solvents damage

plastic parts.

Some of these are: gasoline,

carbon tetrachloride, chlorinated cleaning

solvents, ammonia and household detergents

that contain ammonia.

!

WARNING

!

WARNING

Maintenance

!

CAUTION

BM 2609932608 07-07 7/10/07 8:09 AM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Komentáře k této Příručce

Žádné komentáře