Bosch TOURING 7500 SERIES Návod k obsluze Strana 214

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 260
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 213
4 Click a column title to sort the table by this column.
Encoder
Displays the device type.
Camera
Displays the name of the camera.
Network Address
Displays the IP address of the camera.
Location
Displays the location of the camera. If the camera is not assigned to a location yet,
Unassigned Location is displayed.
Number
Click a cell to edit the logical number that the camera received automatically when it was
detected. If you enter an already used number, a corresponding error message is displayed.
The logical number is "free" again when the camera is removed.
Audio
Click a cell to assign an audio source to the camera.
If an alarm occurs with low priority and with a camera that has audio configured, this audio
signal is played even when an alarm with higher priority is currently being displayed. But this
is only true, if the high priority alarm has no audio configured.
Stream 1 - Codec / Stream 2 - Codec (only VRM and Local Storage)
Click a cell to select the desired codec for encoding the stream.
The following entries are available:
MPEG-4 SH++ (only for encoders that do not support H.264)
Classic codec for MPEG-4 encoding.
H.264 BP+ (only for VIPX and ARM)
Codec for H.264 encoding with the Baseline+ Profile optimized for low bit rates. Use for
live viewing with VIPX.
Note: If live video is to be displayed on a VIPX Decoder, select H.264 BP+.
H.264 MP (only for VIPX)
Codec for H.264 encoding with the Main Profile optimized for efficient encoding. Use for
recording.
H.264 MP Low Latency (only for ARM)
Codec for H.264 encoding with the Main Profile optimized for low bit rates and efficient
encoding. Use for live viewing and recording.
For ARM: Use H.264 MP Low Latency for both live viewing and for recording.
Stream 1 - Quality / Stream 2 - Quality
Select the desired quality of the stream used for live or recording. You configure quality
settings in the Stream Quality Settings dialog box.
Live Video (only VRM and Live Only / Local Storage)
Click a cell to select the stream for a VRM or a local storage / live only encoder.
Recording - Device Family
Displays the name of the device family to which the selected camera belongs.
Recording - Setting (only VRM and Local Storage)
Click a cell to select the required recording setting. You configure the available recording
settings in the Scheduled Recording Settings dialog box.
(Only visible when you click All)
Select a check box to activate PTZ control.
214
en | Cameras and Recording page Bosch Video Management System
2013.07 | V1 | Configuration Client Configuration Manual Bosch Sicherheitssysteme GmbH
Zobrazit stránku 213
1 2 ... 209 210 211 212 213 214 215 216 217 218 219 ... 259 260

Komentáře k této Příručce

Žádné komentáře