Bosch PAD10000 Manuál s instrukcemi stáhnout pdf (Strana 11)

7

Frost protection

The appliance is equipped with a frost

protection thermostat. This automatically

switches the compressor off in order to pre-

vent ice forming in the appliance. It starts

automatically as soon as the temperature in

the room reaches the right level for opera-

tion. The appliance can thus be used in low-

temperature environments without causing

problems. Indicator lamp

3

is lit while the

frost protection feature is activated.

General information

When used within enclosed rooms at

relative humidity levels exceeding 30%, the

dehumidiﬁ er removes moisture from the air

and collects the water that condenses out.

This signiﬁ cantly reduces the build-up of

condensation on walls, and prolongs the life

of furniture and electrical appliances.

A relative humidity level of between 40 and

60% is recommended to maintain a pleas-

ant room environment.

Putting the unit into

operation

The appliance is ﬁ tted with a handle

10

and

castors

11

to make it easier to transport.

● Position the dehumidiﬁ er on an even, ﬁ rm

surface.

● Turn the rotary switch

1a

to “off”, uncoil

the power cord

12

and plug in.

● Set the desired relative humidity level

with the rotary switch

1a

.

Info

: The dehumidiﬁ er only begins to

operate when the humidity in the room is

higher than the level set. The indicator lamp

1

is lit while the appliance is dehumidifying,

and goes out when the ambient humidity

reaches the value set. Should the humidity

level in the air rise, the dehumidiﬁ er is

automatically switched on again.

en

Operation with water tank

or long-term use

The condensate water produced by the

dehumidifying process can either be

directed into the removable water tank

4

or via the drainage connection

8

through a

hose into an external receptacle or drain.

Operation with water tank

The water tank

4

contains an integrated

ﬂ oat

5

, which automatically switches the

appliance off when the maximum capacity

is reached.

Please ensure that the ﬂ oat is not

obstructed, and that it contains no water.

● If the indicator lamp

2

lights up, remove

the water tank

4

, empty it and replace it

again.

● Indicator lamp

2

will go out, and the

appliance will automatically restart.

Info

: Indicator lamp

2

will also come on if

the tank is not properly in place.

Important

: In order to prevent the

compressor malfunctioning, do not remove

and replace the water tank repeatedly in

quick succession.

Operation with drainage connection

(Fig. 13)

● Set the rotary switch

1a

to “off”, unplug the

appliance and remove the water tank

4

.

● Open the drainage outlet

7

on the back of

the appliance.

● Firmly connect the hose supplied to

the drainage connection

8

and position

the other end of the hose over a large

collecting vessel or a drain.

● Replace the water tank

4

and restart the

appliance.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 39 40

Komentáře k této Příručce

Žádné komentáře