Bosch VG4-100 Series Instalační manuál stáhnout pdf (Strana 34)

34 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts VG4 Modular Camera Series

F.01U.162.025 | 6.0 | 2010.03 Installation Manual Bosch Security Systems, Inc.

4. Hold the Pendant housing in position while tightening the two (2) 5-mm Allen head

mounting screws on top of the housing to 10-12 N-m (90-105 in.-lbs).

Removing the Pendant Bubble

To service the AutoDome Pendant, use the following procedure to remove the Bubble:

1. Using both hands, apply a counterclockwise (looking up at the dome) rotational force on

the Pendant Bubble Assembly to set the bubble latch.

2. Insert a small (2 mm) straight blade screw driver into the bubble release opening in the

bubble trim-ring to release the lock, and then remove the screwdriver. See the figure

below.

3. Rotate the Bubble Assembly counterclockwise approximately 20 degrees until the bubble

assembly releases from the Pendant Housing.

Figure 2.18 Pendant Bubble Release Opening

CAUTION!

You must tighten the two mounting screws to a minimum torque of 10-12 N-m (90-105 in.-lbs)

to ensure a proper seal between the arm and the housing.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 107 108

Žádné komentáře

Bosch VG4-100 Series Instalační manuál Strana 34