Bosch LTC 1271 Series Instalační manuál stáhnout pdf (Strana 19)

C2431M-I (4/07) 19

6. Check the wiring to the controller. Refer to the ExSite documentation and the documentation

supplied with your controller to make sure the wiring is correct.

7. Set the DIP switches on the ExSite system (refer to Figure 19 for switch location):

a. SW3: Verify that all SW3 switches on the ExSite power module are set to the OFF position.

b. SW1: Set the ExSite address (refer to Table E on page 43 of the Appendix for switch settings).

8. Attach the pan and tilt unit to the power module (refer to Figure 16 and Figure 17 on page 17):

a. Align the pan and tilt unit with the power module. Carefully begin to hand tighten the locking

ring onto the threads of the power module.

b. Continue to tighten the locking ring with a spanner wrench.

c. Tighten the setscrew in the locking ring with a 2 mm Allen wrench.

NOTE: Refer to the installation manual supplied with the ExSite system for instructions on attaching

the pan and tilt unit to the power module.

9. Apply power to the system. The following message appears on the monitor as soon as the ExSite

configuration cycle is completed:

TXB-B Rev x.xx yy

NOTE: x.xx represents the current firmware revision. yy represents the termination setting.

Bosch (Philips, Burle)

Controller ExSite Wire Harness

+ RX+ (Red)

-RX- (Green)

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 47 48

Žádné komentáře

Bosch LTC 1271 Series Instalační manuál Strana 19