Bosch DS7445i Uživatelská příručka Strana 18

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 54
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 17
Page 18 P/N: 49211C © 2002 Detection Systems, Inc. All rights reserved. DS7240/DS7220 User's Guide
PART II: KEYPAD USER’S GUIDE: DS7447i LCD KEYPAD
4.20 Check System Troubles
Key Sequence: [#] + [4]
Description
Your system emits a trouble tone and displays the
System Trouble message to alert you to a system
trouble event. Things such as low batteries cause
system troubles. Use this function to learn what is
causing the trouble and what steps to take to correct
it.
Procedure
1. The system may be on or off when a system
trouble occurs. If the system is on, you must turn
it off to check the trouble. The keypad displays:
Trouble! Press
# 4 to view.
2. Enter [#] + [4]. The trouble silences and the
keypad scrolls through the list of troubles. Follow
the keypad display instructions to see the trouble
events:
Zone Trouble!
Press 8 to view.
Alarm Memory!
Press 0 to view.
Date/time lost!
Press 5 to set.
System Trouble!
Press 2 to view.
To Test System,
press 1.
To Walk Test,
press 4.
To reset,
press 7.
System OK!
Press #.
The list of keypad displays above represents the
variety of System Trouble displays that may
occur.
3. Press the [#] key to return the keypad to the
normal display.
The Trouble tone continues until the situation is
acknowledged by using the procedure detailed
above.
If Trouble messages persist, contact your
Security Company for assistance.
The trouble tone for AC Failure events sounds
at all keypads in all areas. However, the
trouble tone must be silenced in each area
(silencing the trouble tone in one area does
not silence it in the other areas).
4.21 View Alarm Memory
I can perform this function.
I cannot perform this function.
Key Sequence: [#] + [4] + [0]
Description
After an alarm has been silenced and cleared from
the display, you may still review the zones that
alarmed.
Procedure
1. Make sure that the system is turned off (Armed
LED is off).
2. Enter a valid user PIN.
3. Enter [#] + [4] + [0].
The keypad displays all zones in alarm memory.
In this example, the keypad displays that Zone 5
has alarmed:
Alarm Zn 5
Bedroom 1 Window
If you enter your PIN before the system reports to
your Security Company, the keypad displays:
Abort Zn 5
Bedroom 1 Window
When the last alarm is shown, the keypad
displays:
To clear memory,
Turn system On.
Clear the memory by turning the system on (arm)
and off (disarm).
If no alarm is present, the keypad displays:
No alarms in
System memory.
The keypad then returns to the normal display.
Zobrazit stránku 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 53 54

Komentáře k této Příručce

Žádné komentáře