Bosch DS7445 Uživatelská příručka stáhnout pdf (Strana 28)

- 28 -

This chart will guide you through the steps necessary to change a PIN.

You should write down your entries before you enter the Master Code Programming Mode

and have them with you as you begin programming. Make your entries promptly.

If a delay of 15 seconds or more occurs between your entries, the 3-beep error tone occurs

and exits you from the programming mode.

Personal Identification Numbers (continued)

It is recommended that this procedure be performed at a DS7447 keypad. No visual clues will be given from a D7445 keypad.

Note: If a Master PIN is not assigned to at least all

the areas that the PIN being changed is as-

signed to, the Master PIN will not be allowed

to alter that PIN.

continued on next page

If Accepted, DS7447 Displa

Reads

Command

Sequence

[Master Code] + [#] [0]

[0]

Steps to Chan

e a PIN

1. Enter the Master Code Pro

rammin

Mode.

[0] [0] [1] throu

h [0] [9] [0]

[0] throu

h [6]

[1], [2], [3], [4], [5], [6],

[7], and/or [8] then [#]

“0 User Chan

e” (displa

will scroll to this)

“Enter User No”

(001 ... 0xx)

“Enter Authorit

Level”

Level (0-6)

“Enter Area(s) or # for all”

“Enter Next Area, End with #” or

“Enter PIN”

2. Enter a 0.

3. Enter the User Number.

4. Enter the Authorit

Level.

5. Enter the Area(s) (partition[s]) this user has

access to.

6. Enter the PIN.

7. Enter the PIN a

ain followed b

the [#] ke

4 di

its

Do not press [#]

[PIN] (same as 4 di

its

as above), then [#]

“Enter PIN A

ain. End with #”

A lon

beep will sound to si

nif

acceptance of the new PIN

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Komentáře k této Příručce

Žádné komentáře

Bosch DS7445 Uživatelská příručka Strana 28

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Bosch DS7445