Bosch ICP-VR8488 Uživatelský manuál stáhnout pdf (Strana 7)

ICP-VR8488 | User's Guide | 10.0 Glossary of Terms EN | 7

Bosch Security Systems, Inc. | 12/08 | F01U089638-01

10.0 Glossary of Terms

Table 3: Glossary of Terms

Term Description

24-hour zone A monitored input where tamper switches and emergency switches can be

connected. If one of these switches is violated at any time (whether the system is

armed or disarmed), an alarm is reported.

alarm condition The status when an alarm system is armed and one of the detection devices is

violated. A 24-Hour zone (for example, a smoke detector) can activate when the

system is armed or disarmed.

AWAY Mode The mode used to arm your system when you leave your premises.

codepad A device that allows you to perform all functions such as arming, disarming, and

programming of your alarm system.

detector A unit installed as a satellite component in a security system designed to detect an

intruder within a protected area. Some common forms of detection devices are

passive infrared, smoke, photo electric beams, reed switches, and vibration sensors.

dialer An electronic device that uses tones or pulses to dial an electronic receiver such as

a monitoring station, mobile phone, or pocket pager. It uses the public switched

telephone network to send alarm or supervisory signals.

disarmed A system status that does not accept alarms, except for 24-hour zones.

entry delay A programmed delay of the system alarm responses that allows a person to enter a

building through the entry door to turn the system off.

entry warning The beeping from a codepad during an entry delay as a reminder to disarm the

system.

exit delay A programmed delay of the system alarm responses that allows a person to leave a

building after turning the system on.

keyfob A hand-held transmitter that you can use to arm and disarm your system, or to

initiate a panic alarm.

master code A numeric code used for arming and disarming the system, and for allowing access

to all functions available through the codepad.

monitoring station A secure location where a digital receiver monitors a number of alarm systems and

deciphers their alarm transmission reports so the operator can advise the

appropriate authorities to take immediate action.

panic A condition or type of alarm in which the user requires either immediate police or

medical assistance.

sealed Refers to a zone’s status. If a zone is sealed, the detection devices are not violated

and the zone indicator is not lit (that is, a reed switch is closed or a detector is on

standby waiting for an intrusion).

silent alarm An alarm that sounds only at a remote location, and gives no obvious local

indication that an alarm was sent out.

STAY Mode 1 A condition that automatically isolates certain zones when the security system is

armed in this mode. Only the installer can program these zones.

STAY Mode 2 A condition that automatically isolates certain zones when the security system is

armed in this mode. The Master Code holder can program these zones.

unsealed or faulted Refers to a zone’s status. If a zone is unsealed, the detection devices are violated

and the zone indicator is lit (that is, a reed switch is open or a detector noted an

intrusion).

user code A numeric code used to arm and disarm the system.

zone A monitored input used to activate an alarm. A zone might be set up to activate an

alarm only when the system is armed or to operate whether the system is armed or

disarmed.

1 2 3 4 5 6 7 8 9 10 11 12

Komentáře k této Příručce

Žádné komentáře

Bosch ICP-VR8488 Uživatelský manuál Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Bosch ICP-VR8488