Bosch 1943 LED Specifikace stáhnout pdf (Strana 7)

7Bosch Security Systems, Inc. | 09/06 | 31344F

1 - Aim Mode button 2 - Green LED

Figure 9: Transmitter Circuit Board Showing Aim

Mode Button

6.0 Setup

Before performing a setup, ensure all connections are

made and secure. Then, apply power to the transmitter

and receiver.

1. Press the transmitter’s Aim Mode button, located

above the green LED (refer to Figure 9) allowing it

to power up while the cover is off.

2. Ensure the green LED flashes on and off. If this

LED is off, check for power and proper polarity on

Terminals 1 (–) and 2 (+). If the green LED is

steadily lit, you have a faulty transmitter. Return the

transmitter to the factory.

3. Check the three receiver LEDs (refer to Figure 10).

It is normal for all three LEDs to be on at this time,

with the green LED either flashing or steadily on.

If all LEDs are off, check for power and proper

polarity on Terminals 8 (–) and 9 (+).

4. Mount a D309 Strobe Aiming Light or an

equivalent, such as a Faraday 5508, as close to the

receiver as possible, preferably on top of the

receiver.

5. Point the D309 at the transmitter using it as your

aiming guide. An aiming light might not be

necessary for short distance separations.

D296/D297 | Installation Instructions | 6.0 Setup

1 - Alarm LED (red)

2 - Trouble LED (yellow)

3 - Normal LED (green)

Figure 10: Receiver LEDs

6.1 Preliminary Alignment

Each optical module has two alignment mirrors, one on

each side, for an initial alignment (refer to Figure 11).

1. Look into either mirror from a side angle that is a

minimum of 2 ft (61 cm) from the module.

The optical module points at objects seen in the

mirror when the orange-colored front bore sight is in

the center of the rear bore sights (refer to Figure 12).

Use the rear and front sights in the same way as you

use sights when aiming a gun.

2. Rotate the transmitter's optical module left or right

until you see the aiming light image (or receiver

image, if aiming light is not used) in the mirror.

3. If optical module is initially aimed too high or too

low, adjust the Vertical Fine Tuning adjustment Allen

screw (with the supplied Allen wrench) slightly up or

down until you see the image.

4. Use the Vertical Fine Tuning adjustment screw and

the Horizontal Fine Tuning adjustment screw to fine

tune the image to the center of the mirror (aligned

with the front and rear bore sights).

5. Replace and secure the transmitter's cover.

6. Ensure the transmitter's green LED is flashing.

7. Replace and secure the transmitter's access door.

1 - Vertical fine tune 5 - Alignment mirror (3)

2 - Front view 6 - Rear bore sight (2)

3 - Horizontal fine tune 7 - Front bore sight

4 - Side view

Figure 11: Optical Module

1 - Rear bore sight (2) 2 - Front bore sight

Figure 12: Alignment Mirror

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Komentáře k této Příručce

Žádné komentáře

Bosch 1943 LED Specifikace Strana 7

Komentáře k této Příručce

Související produkty a manuály pro Elektrické nářadí Bosch 1943 LED