
GV3 Series v8.11 or Higher Table of Contents | en 3
Bosch Security Systems, Inc. Quick Reference Guide F01U170805 | 02 | 2011.10
Table of Contents
1 GV3 Control Panel Connections (D9412GV3 Shown) 5
2 Upgrade GV3 Hardware and Programming 7
2.1 Receive Existing Control Panel Programming 7
2.1.1 Receive Existing Control Panel Programming with RPS 7
2.2 Upgrade Hardware to a GV3 Series Control Panel 7
2.2.1 Prepare to Remove Existing Hardware 7
2.2.2 Remove the Existing Control Panel 7
2.2.3 Install the GV3 Control Panel In the Enclosure 8
2.2.4 Replace the Terminal Strips 8
2.3 Upgrade Programming to a GV3 Control Panel Programming 9
2.3.1 Upgrade a GV2 Series, G Series, or Non-G Series Control Panel to a GV3 v8.03 or Later Using Remote
Programming Software (RPS) 5.13 or Later9
3 Programming the Control Panel 10
3.1 RPS Programming over a Network Using the DX4020 Ethernet Network Interface Module 10
3.2 RPS Programming over a Network Using the ITS-DX4020-G GPRS/GSM Communicator 10
3.3 RPS Programming Using the DX4010V2 RS-232/USB Serial Interface Module 10
3.4 RPS Programming Using the Keypad Programming 10
4 Programming to Set Up Central Station Reporting 11
4.1 Basic Telephone Set Up in RPS 11
4.2 Basic Internet Protocol (IP) 11
4.3 Account Number 11
5 Programming the Control Panel for Common Reporting Options 12
5.1 Set Up Daily Test Report Using RPS 12
5.2 Set Up Open and Close Reports Using RPS 12
5.2.1 Area Wide Parameters 12
5.2.2 Set Authority Level 12
6 Setting Up Points and Outputs 13
6.1 Using the Relay Option Within Point Assignments 13
6.2 Point Index (Default Values) 14
7 Add System Users Locally With a Keypad 16
7.1 Add Users (CMD 56) Using a Keypad 16
7.2 Add Card (CMD 56) for Access Control Only Using a Keypad 16
8 Turning the System ON or OFF and Keypad Commands 17
8.1 Arming and Disarming the System 17
8.1.1 Master Arming 17
8.1.2 Disarming 17
8.1.3 Set Duress +1 Using RPS 17
Komentáře k této Příručce