Bosch VIP XD Uživatelský manuál stáhnout pdf (Strana 18)

Installation and Operating Manual | VIP XD

EN | 18

Installation Bosch Security Systems | 2005-10 | V1.5

Connections

Monitors

If required, you can connect an analog video monitor (PAL/NTSC) or a VGA-

compatible computer monitor.

– Connect an analog video monitor to the BNC jack Video Out with a video

cable (75 Ohm, BNC connector)

– Connect a VGA compatible computer monitor to the Sub-D jack VGA with a

video cable (VGA, 15-pin Sub-D connector).

Audio connections (audio version only)

The audio version of the VIP XD has two audio ports for audio line signals as

well as a microphone input and a loudspeaker output.

The audio signals are transmitted both ways and in sync with the video signals.

This means that you can operate, say, a loudspeaker or door interphone at the

destination site.

Note

If possible you should use the line ports of the interphone for transmitting

audio signals on interphone systems. The following specifications should

be complied with in all cases.

Line In: Impedance 9 kOhm typ., 5.5 V

p-p

max. input voltage

Line Out: Impedance 16 Ohm min., 3 V

p-p

max. output voltage

MIC (microphone): Impedance 2 kOhm typ., 2.8 V

p-p

max. input voltage,

-20 dB in, supply 2.3 V typ.

SPK (loudspeaker): Impedance 4 Ohm min., 6 V

p-p

max. output voltage,

power output 1 W rms

The stereo jack plugs must be connected as follows:

Contact VIP XD

Tip Channel 1

Middle ring Not used

Lower ring GND

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 97 98

Žádné komentáře

Bosch VIP XD Uživatelský manuál Strana 18