Bosch CS 150 RC Manuál s instrukcemi stáhnout pdf (Strana 9)

Praesideo PRS-CSM / PRS-CSRM / PRS-CSKPM en | 9

Bosch Security Systems B.V.

IUI PRS-CS(R)(KP)M | V1.0 | 2013.12

Installation and User Instructions

1.2.5 Control input/outputs (5, 6)

These two 6-pin connectors provide the connection of

one control input for the PTT key and five control

outputs for indicator LEDs.

The PTT input contact on this connector is in parallel

with the PTT input contact on connector 2. Use only

one of them.

See figure 1.9 for a connection diagram. The two

resistors must be placed in the circuit, because the

contact is always supervised by the system software.

In figure 1.10 the LED driver circuit is shown.

Typical colors for the indicator LEDs are:

• Green for power and call status indicators;

• Yellow for fault and system fault indicators;

• Red for the emergency indicator.

table 1.5: Control inputs/outputs connector details

Pin Signal

1 PTT input contact

2 GND

3 LED Power Indicator +/anode

4 LED Power Indicator -/cathode

5 LED Fault Indicator +/anode

6 LED Fault Indicator -/cathode

7 LED Call Status Indicator +/anode

8 LED Call Status Indicator -/cathode

9 LED Emergency Indicator +/anode

10 LED Emergency Indicator -/cathode

11 LED System Fault Indicator +/anode

12 LED System Fault Indicator -/cathode

Warning

Do not connect DC or AC signals to the control

inputs, otherwise the input circuit may be

damaged. Only use voltage-free contacts.

figure 1.9: Press-to-talk (PTT) key

GND

PTT Input

Contact

10 kΩ

figure 1.10: Internally powered LEDs

Pwr: Power indicator

Fault: Fault indicator

Call: Call status indicator

Emg: Emergency indicator

Syst Fault: System fault indicator

+5V, 30 mA

62V 62V

Pwr Fault Call

Syst

fault

Emg

62V

330: 330: 330: 330: 330:

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

Komentáře k této Příručce

Žádné komentáře

Bosch CS 150 RC Manuál s instrukcemi Strana 9

Komentáře k této Příručce

Související produkty a manuály pro Sítě Bosch CS 150 RC