Bosch GCM12SD Návod k použití a péči stáhnout pdf (Strana 11)



Assembly

Combination Square Must Be True - Checking Combination Square

1. Position square and

draw a light line

2. Flip square (shown in dotted position)

3. Check edge of flipped square against

the drawn line. There should be no gap

or overlap at the bottom end.

drawn line

3/4" board with

straight top edge

no gap or overlap

Tools Needed for Assembly and Alignment

Combination Square

6/4mm Hex Key

(supplied)

10mm Socket

(supplied)

#2 Phillips Screwdriver

NOTE: A 6mm and a 4mm hex key can be

substituted for the supplied 6/4mm hex key.

BM 2610007877 08-10:BM 2610007877 08-10.qxp 8/24/10 1:04 PM Page 11

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 163 164

Žádné komentáře

Bosch GCM12SD Návod k použití a péči Strana 11